Dress up your case mod with flexible, easy to 
install GLOWIRE.  

  Kits include a molex connector attached to the driver that will plug in to your computer's 12 volt power supply.  No soldering involved.

  Simply plug in and you're ready to glow!

Kit #1
*12 volt driver with built in switch to select on/off/flash mode, molex connector, 2 output 
lines for GLOWIRE
*One 5 foot section of GLOWIRE
$24.95

Kit #2
*12 volt driver with built in switch to select on/off/flash mode, molex connector, 2 output
lines for GLOWIRE
*Two 5 foot sections of GLOWIRE
$35.99

                    Kit #3
*12 volt driver with variable light intensity control, molex connector, on/off switch and 4 separate
connector outputs
*Three 5 foot sections of GLOWIRE
$44.95

                    Kit #4
*12 volt driver with variable light intensity control, molex connector, on/off switch and 4 separate 
connector outputs
*Four 5 foot sections of GLOWIRE
$52.95

Extra 5' Wire Sections
Want to change colors or add another section of GLOWIRE to an unused port?  We now offer individual 5' sections.
$14.95

NEW - MOUNTING TAPE
Mounting your GLOWIRE is now easier than ever with our 1/8" 3M high bond clear double-sided tape!  Lay your tape where you want it, peel off the coating and lay your GLOWIRE down.  Comes in 24 foot rolls.
$7.50/roll